|
|
Same day.
Date: 03/13/2005
Owner: Mark Briggs
Views: 269
|
|
Test cut of bunkap material with chop saw.
Date: 02/08/2005
Owner: Mark Briggs
Views: 258
|
|
Got port bunkap on, ready to lower and test final tilt angle and alignment
Date: 02/08/2005
Owner: Mark Briggs
Views: 254
|
|
|
First time out.
Bunkaps still look like new.
Date: 03/13/2005
Owner: Mark Briggs
Views: 239
|
|
Port and starboard sides complete-lookin' good
Date: 02/08/2005
Owner: Mark Briggs
Views: 227
|
|
Old carpeted bunks with EZ slides. Note chalky green powder at the end of each sagging board where the gelcoat has been "ru
Date: 02/08/2005
Owner: Mark Briggs
Views: 224
|
|
|
2x3 support system to lift ski by gunwales, one side at a time.
Date: 02/08/2005
Owner: Mark Briggs
Views: 222
|
|
70-inch pressure treated bunk lumber with 78-inch bunkap before trim
Date: 02/08/2005
Owner: Mark Briggs
Views: 219
|
|
70-inch pressure treated bunk lumber with 78-inch bunkap before trim
Date: 02/08/2005
Owner: Mark Briggs
Views: 218
|
|
|
2x3 support system to lift ski by gunwales, one side at a time.
Date: 02/08/2005
Owner: Mark Briggs
Views: 217
|
|
Bunk centered between hull "ribs"
Date: 02/08/2005
Owner: Mark Briggs
Views: 217
|
|
Old bunk autopsy-old redwood dry and cracked.
Date: 02/08/2005
Owner: Mark Briggs
Views: 204
|
|
|
Old carpeted bunks with EZ slides. Note chalky green powder at the end of each sagging board where the gelcoat has been "ru
Date: 02/08/2005
Owner: Mark Briggs
Views: 193
|
|
Typical rusty bunk support bracket and rusty screws.
Date: 02/08/2005
Owner: Mark Briggs
Views: 192
|
|
Nice aft
Date: 02/08/2005
Owner: Mark Briggs
Views: 188
|
|
|
Measuring and pre-drilling holes in bunkaps sides the night before 10" spacing
Date: 02/08/2005
Owner: Mark Briggs
Views: 183
|
|
Removing old bunk
Date: 02/08/2005
Owner: Mark Briggs
Views: 179
|
|
New hardware, wooden bunk and bunkap
Date: 02/08/2005
Owner: Mark Briggs
Views: 179
|
|
|
Test final fit of brackets
Date: 02/08/2005
Owner: Mark Briggs
Views: 179
|
|
Scrap left after cuts
Date: 02/08/2005
Owner: Mark Briggs
Views: 174
|
|
Finally, adding the bunkaps to bunk boards
Date: 02/08/2005
Owner: Mark Briggs
Views: 171
|
|
|
Port and starboard sides complete-lookin' good
Date: 02/08/2005
Owner: Mark Briggs
Views: 170
|
|
Old bunk with hard water scale in carpet. Note support T
Date: 02/08/2005
Owner: Mark Briggs
Views: 169
|
|
Final fit with 3/4-inch overhang at each end.
Date: 02/08/2005
Owner: Mark Briggs
Views: 162
|
|
|
Measuring and pre-drilling holes in bunkaps sides the night before 10" spacing
Date: 02/08/2005
Owner: Mark Briggs
Views: 161
|
|
Bolt hole locations
Date: 02/08/2005
Owner: Mark Briggs
Views: 160
|
|
Dry fitting new bunk for bolt hole locations
Date: 02/08/2005
Owner: Mark Briggs
Views: 154
|
